Silvercrest SED 3.7 G3 - Post-Epilation and Head Care; Finishing Epilation and Head Replacement

SED 3.7 G3
■ 14
│
GB
│
IE
│
NI
│
CY
7) When you are finished with the treatment, place the speed
switch  to “0”.
8) Clean the epilator head  as described in the section
“Cleaning and Care”.
9) If necessary, remove the massage roller attachment and place
the protective cap  on the epilator head .
NOTICE
► Stop using the epilator head  immediately if it is damaged!
To order a new epilator head , please contact the Service
Department (see section “Ordering replacement parts”).
To replace the epilator head , please proceed as follows:
― Press the two restraint fixtures  together, and at the same
time pull the epilator head  upwards.
― Press the new epilator head  onto the appliance.
The epilator head  must click into place.