19
GB
~ When the device is connected for
charging:
- Protect the device and power unit
from moisture and dripping or splash-
ing water.
- If liquid gets into the device, immedi-
ately disconnect the power unit. Have
the device checked before reusing.
- Do not touch the device or power unit
with wet hands.
DANGER! Risk of electric
shock
~
Never put the device into operation if there
is any visible damage to the device, the
power unit or the cable or if the device has
been dropped before.
~ Connect the cable to the device before
plugging the power unit into a wall
socket.
~ Only connect the power unit to a prop-
erly installed, easily accessible wall
socket, the voltage of which corre-
sponds to the specifications on the rat-
ing plate. The wall socket must still be
easily accessible after connection.
~ Ensure that the cable cannot be dam-
aged by sharp edges or hot surfaces.
~ Ensure that the cable is not trapped or
crushed.
~ When removing the power unit from the
wall socket, always pull the power unit
and never the cable.
~ Pull the power unit out of the wall sock-
et, …
… after each charging process,
… if there is a fault,
… before connecting the device to the
cable,
… before you clean the device and
… during thunderstorms.
~ In order to avoid any hazards, do not
make modifications to the device. Re-
pairs must be carried out by a specialist
workshop or the Service Centre.
DANGER from batteries
~ This device contains a battery that can-
not be removed. The battery may only
be removed or replaced by the manu-
facturer, the manufacturer's customer
service department or a similarly quali-
fied specialist, in order to avoid any
hazards.
~ Protect the battery against mechanical
damages. Fire hazard!
~ Do not expose the device to direct sun-
shine or heat. The ambient temperature
should not be lower than -10 °C and
higher than +40 °C.
~ The
battery
may only be charged with
the original accessory (power unit).
~ Should the electrolyte solution leak out
of
the battery
, avoid contact with eyes,
mucous membranes and skin. Rinse im-
mediately with plenty of clean water
and consult a doctor. The electrolyte
solution can cause irritation.
WARNING! Risk of material
damage
~ Only use the original accessories.
~ Do not use the window cleaner on sensi-
tive surfaces that can be easily
scratched.
~ Only fill the water tank with cold, clear
tap water. Do not use chemical sub-
stances, cleaning agents or other liq-
uids. Single exception: you can use a
few drops (1 to 3) of mild detergent or
glass cleaner concentrate (to dissolve in
the cleaning water).
~ Do not use abrasive or harsh cleaning
agents with the window cleaner.
~ Never place the device on hot surfaces
(e.g. hot plates) or near heat sources or
open fire.
~ To prevent overheating, do not cover the
power unit.
~ Do not use harsh or abrasive cleaning
agents to clean the window cleaner.
__334427_Fensterreiniger_B8.book Seite 19 Dienstag, 5. Mai 2020 1:33 13
To Next Page
Loading...
Need help?
General
