Silvercrest SGBR 1500 B3 - Using the rotisserie

SGBR 1500 B3
GB
│
CY
│
7 ■
Using the rotisserie
WARNING! RISK OF INJURY!
► Always use the tongs 3to insert the hot rotis-
serie 6 into the appliance or to remove it.
■ You can use the two skewer clamps 0 to fix the
food onto the rotisserie 6. Loosen the restrainer .
on the skewer clamps 0, push them so that the
food is fixed firmly in between the clamps and
then screw the restrainer . tight again.
■ First push the end of the rotisserie 6 without the
notch into the drive  (Figure 1):
Fig. 1: Push the rotisserie 6 into the drive .
■ Then insert the other end of the rotisserie 6 with
the deep groove in the spit fitting  (Figure 2):
Fig. 2: Insert the rotisserie 6 in the spit fitting .
NOTE
► Always slide the baking tray - into the lower
rail when you use the rotisserie 6.
This will collect any drips.
■ To remove the hot rotisserie 6, grip with
the hooks at the end of the tongs 3 into the
recesses on the rotisserie 6 (Figure 3):
Fig. 3: Hooking the tongs 3 onto the rotisserie 6
■ F
irst lift the left-hand side of the rotisserie 6 out
of the spit fitting  and then pull the rotisserie 6
from the drive .