20 GB/IE
Cleaning and care / Disposal
j After cleaning, place the locating lug of the blade set
1
back
into the locating hole of the cutter head mount (see Fig. C).
j Re-engage the blade set
1
by applying a little light pressure from
the rear of the device (see Fig. D).
Tip: To reduce friction apply one or two drops of cutter oil (accessory)
from time to time between the blades and spread it out evenly. You
may also use any acid-free oil (such as sewing machine oil). Wipe
away any excess oil with a cloth.
Q
Disposal
This hair and beard clipper contains two NiMH rechargea-
ble batteries.
The batteries should be discharged before disposal.
j Disconnect the device from the power supply.
j Switch the device on and allow it to continue to operate until it
switches itself off.
j Press the release button on the back of the device (bottom) to
remove the rechargeable batteries from the device (see Figs. E - G).
Now you can dispose of all the components in accordance with the
regulations.
You are not permitted to throw away single-use or recharge-
able batteries with household refuse. Please dispose of
single-use or rechargeable batteries through a battery
return system or a battery collection point run by your
dealer or local council.
To Next Page
Loading...
