11 GB/CY
Safety / Before getting started
To avoid fire:
J Remove the AC adaptor plug after using the appliance or in order to clean it.
J Never allow the appliance to operate unsupervised and only in accordance with the
details on the rating plate.
J Remove the AC adaptor plug from the socket
– in the event of a disturbance,
– before cleaning the appliance,
– if you do not intend to use the appliance for any length of time,
– after every use.
Pull on the plug and not on the cable.
J Should any damage to the cable, the AC adaptor plug, the casing or any other parts be
ascertained, the appliance must not be used any more.
J Only use the original AC adaptor plug supplied for mains operation.
J Insert the AC adaptor plug only into a socket that is within easy reach.
J Do not cover the AC adaptor plug in order to prevent any inadmissible warming from
occurring.
Q
Before getting started
The hair and beard trimmer can be operated as a battery-driven or mains-operated appliance
(with an AC adaptor plug).
Q
Operation with an AC adaptor plug
j First insert the adaptor cable into the port
7
of the hair and beard trimmer and insert the
adaptor into a properly installed socket (230 V
~
).
j Make sure that the ON / OFF switch
5
is pushed down (OFF position).
The hair and beard trimmer can be used immediately when connected to the mains. With
mains operation of the hair and beard trimmer, the state-of-charge display
6
will alternately
flash green and red.
Q
Charging the rechargeable batteries and battery operation
Tip: The rechargeable batteries of the hair and beard clippers achieve optimal performance
after they have been charged and discharged 3 times. Before using it for a first time as well as
for the following 3 charging processes, charge the hair and beard trimmer for 12 hours.
To Next Page
Loading...
