EasyManua.ls Logo

Silvercrest SHGD 52 A1 - Appliance Usage; Automatic Switch-off and Filling Water Tank

Silvercrest SHGD 52 A1
85 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GB7
SHGD 52 A1
Automatic switch-off
This appliance is fitted with an automatic switch-off system. After 60 minutes
(+/− 6 minutes), the appliance will switch itself off automatically. If you want to
continue using the appliance, switch it off for a moment and then back on again.
NOTE
The automatic switch-off is a safety function only and is not intended as a
replacement for switching the appliance off properly using the ON/OFF
switch !
Use
Filling the water tank
NOTE
Fill the water tank only when you want to generate steam for straightening.
1) Unscrew the top of the fill bottle - and fill it with water. Screw the top back
on the fill bottle -.
2) Pull the water tank backwards and out of the appliance.
3) Open the black rubber closure on the water tank . When doing so, be
careful that you do not tear the rubber tab to which the rubber closure is
attached completely off the water tank . Pull out the rubber tab only far
enough out of the water tank so that the rubber closure opens and the
filling hole is free.
4) Twist the top off the fill bottle - and guide the tip into the large filler opening
on the water tank . Hold the water tank at a slight tilt when filling it, so
that the water runs downwards.
5) Squeeze the fill bottle - a little so that the water runs into the water tank .
6) When the water tank is filled up to the small opening next to the filler
opening, hold the water tank straight again and remove the fill bottle -
from the filler opening.
7) Close the rubber closure .
8) Push the water tank back onto the appliance so that it clicks audibly back
into place.

Table of Contents

Related product manuals