EasyManua.ls Logo

Silvercrest SHIP 2000 A1 - Operation; Powering On and Off; Adjusting Blower Stages; Setting Air Temperature

Silvercrest SHIP 2000 A1
77 pages
Go to English
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
16
GB
~ Do not touch the hot surfaces of the de-
vice.
~ Allow the device to cool down com-
pletely before you clean it or put it
away.
~ Allow all attachments to cool down be-
fore removing it from the device.
WARNING! Risk of material damage
~ Only use the original accessories.
~ Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
~ Do not use any astringent or abrasive
cleaning agents.
~ Do not expose the device to tempera-
tures below -10 °C or above +40 °C.
4. Items supplied
1 hair dryer|4
1 styling attachment|2
1 diffuser|1
1 set of operating instructions
5. Operation
NOTE: before using it for the first time,
switch the device on for a few minutes and
allow it to run at the highest speed and high-
est temperature setting. As a result of the
manufacturing process, you may notice a
slight odour. This is normal and only occurs
during first use. Ensure that the room is well
ventilated.
Switching on and off
1. Connect the mains plug|10 with an
easily accessible wall socket.
2. In order to switch the device on put the
on/off switch|11 to 1 (on).
The device starts with the settings se-
lected last (temperature setting, blower
stage, cooling function, ion function)
and shows these on the display|5.
3. After drying, switch the on/off
switch|11 to 0 (off) and pull out the
mains plug|10.
Selecting the blower stage
The air flow can be regulated via 5 blower
stages. The selected blower stage is shown
on the display|5 within the display of the
blower stages |19. The more bars are
shown and the faster the fan symbol turns,
the higher is the setting of the blower stage.
Use the buttons for the blower stages
+/–|13 to select the desired blower
stage.
Selecting the temperature setting
The temperature of the air flow can be regu-
lated via 5 temperature settings. The select-
ed temperature setting is shown on the
display|5 within the display of the tempera-
ture settings |16. The more bars are
shown, the higher the setting of the temper-
ature stage.
Gradually, the air flow becomes hotter or
cooler. The actual temperature is shown on
__291951_Haartrockner_mit_Ionenfunktion_AC_B8.book Seite 16 Donnerstag, 21. Dezember 2017 10:07 22

Related product manuals