EasyManua.ls Logo

Silvercrest SHSK 3.7 A1 - Hair Cutting Procedures

Silvercrest SHSK 3.7 A1
126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
GB
Pushing on
Figure A: to push on one of the comb attachments 7, push
it over the blade unit 1 from the front, and press it upwards
at the rear of the device until it audibly clicks into the
mount 8.
Removing
Release the comb attachment 7 at the mount 8, and push it
forwards off the blade unit 1.
6.3 Cutting hair
DANGER! Risk of electric shock due to mois-
ture!
~ The hair trimmer and the power unit 6 must not be sub-
merged in water, and must therefore not be operated in a
shower/bath.
WARNING! Risk of injury!
~ The tips of the blade unit 1 are sharp. Handle with care.
WARNING!
~ Do not use the device on open wounds, cuts, sunburn or blis-
ters.
NOTE:
Trimming hair is possible both in battery mode and in mains
operation.
Comb through long hair before cutting it.
Select the appropriate comb attachment 7 for the desired
cutting length:
(1.5/2.0/2.5/3.0/4.5/6.0/9.0/12.0/15.0 mm).
__NAS280611_Haarschneider_kompakt_B6.book Seite 13 Freitag, 4. November 2016 6:17 18

Table of Contents

Related product manuals