Silvercrest SIKP 2000 C1 - Trouble-Shooting; Warranty of the HOYER Handel Gmbh

47
GB
14. Trouble-shooting
If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric shock!
~ Do not attempt to repair the de-
vice yourself under any circum-
stances.
15. Warranty of the
HOYER Handel GmbH
Dear Customer,
your device is provided with a 3 year war-
ranty starting with the purchase date. In the
event of product defects, you are entitled to
statutory rights against the vendor. These
statutory rights are not restricted by our war-
ranty presented in the following.
Warranty conditions
The warranty period starts with the purchase
date. Please keep the original purchase re-
ceipt in a safe place. This document is re-
quired to verify the purchase.
If within three years from the purchase date
of this product a material or factory defect
occurs, the product will be repaired or re-
placed by us – at our discretion – free of
charge to you. This warranty implies that
within the period of three years the defective
device and the purchase receipt are present-
ed, including a brief written description of
the defect and the time it occurred.
If the defect is covered by our warranty, the
repaired or a new product will be returned
to you. No new warranty period starts with
a repair or replacement of the product.
Warranty period and statutory
claims for defects
The warranty period is not extended when
the warranty has been claimed. This also ap-
plies to replaced and repaired parts. Any
damages and defects already existing at the
time of purchase must be reported immedi-
ately upon unpacking. Repairs arising after
the expiration of the warranty period are
subject to a charge.
Warranty coverage
The device was produced carefully according
to strict quality guidelines and tested diligent-
ly prior to delivery.
Fault
Possible causes/
Action
No function
• Has the device been
connected to the pow-
er supply?
• Check the connection.
The cooking
zone is not
heating up
• No cooking vessel on
the cooking zone|2?
• Is the cooking vessel
suitable for induction
cooking zones?
Error message
E 1 on the dis-
play
• No cooking vessel on
the cooking zone|2?
• Unsuitable cookware
on the cooking zone?
• Cooking vessel not
placed centrally on the
cooking zone?
Error message
E 7
• The device is overheat-
ed. Switch it off and
let it cool down.
Error messages
E 2 to E 6
• Contact the Service
Centre (see chapter
Warranty)
BB53B,QGXNWLRQVNRFKSODWWHB%ERRN6HLWH'RQQHUVWDJ-XQL