SilverCrest SMA 500 B1
English - 11
6. Before initial start-up
Remove the SMA 500 B1 milk frother and all accessories from the packaging and check the
completeness of the delivery. Remove the protective film. Keep the packaging material away from
children and dispose of it in an environmentally-friendly manner.
7. Initial start-up
Before you prepare milk for consumption for the first time, you must first clean the milk frother in
order to remove dust and any remnants of the packaging material. Follow the procedure described
in the ‘Maintenance/cleaning’ section.
DANGER of electric shock
Keep the base (11) away from water. There is danger of electric shock.
WARNING – Risk of scalding
Only operate the milk frother with the lid (2) on.
WARNING – Risk of injury
Always use fresh milk. Do not consume milk that has been sitting in the canister (7) for
a long period of time.
Please note:
If you lift the canister (7) off the base (11) during operation, the preparation process
stops automatically. Place the canister (7) onto the base (11) again and restart the
process using the On/Off button (10).
You can conveniently store the whisk (4, 5) that is not currently in use in the whisk
holder (1). This is located on the underside of the lid (2).
7.1. Functions of the On/Off button
The On/Off button (10) is used to select the operating mode of the milk frother.
Action LED display Operating mode
Briefly press the
On/Off button (10)
Red LED (9) is on Heating is switched on.
Whisk A (4): Heat milk evenly
Whisk B (5): Make hot milk froth
Press the On/Off
button (10) for an
extended period
Blue LED (8) is
on
Heating is switched off.
Whisk B (5): Make cold milk froth
Briefly press the
On/Off button (10)
during operation
LEDs are off The milk frother is switched off.
To Next Page
Loading...
