Silvercrest SMAS 500 A1 - Page 28

GB
│
IE
│
25 ■
SMAS 500 A1
♦ Remove the container from the base  and fill it with milk. Add enough
milk to reach the MIN mark (= 75 ml) inside the container . However,
you should never fill it with milk beyond the corresponding MAX marking,
otherwise the appliance will spill over:
– up to the lower MAX marking
(= 150 ml), if you want to froth milk
– up to the upper MAX marking
(= 300 ml), if you only want to heat
the milk
♦ Place the container  on the base .
♦ Put the lid  on.
♦ Use the function button
to select the appropriate programme:
– Press once = heat milk with stiff froth
– Press twice = heat milk with creamy froth
– Press three times = heat milk with only a little froth
– Press four times = froth milk without heating
The control lamp for the relevant programme lights up (red = hot, blue =
cold). The selected programme starts automatically.
♦ The appliance switches off automatically at the end of the programme, the
control lamp  goes off.
If you want to stop the preparation process before completion, press the
Function button
 or remove the appliance from the base . You will
have to reselect the programme when you resume the preparation process.
♦ Remove the lid  and pour the milk and/or the milk froth into the desired
container.
♦ Allow the appliance to cool down for about 2 minutes before you froth up
another portion of milk. Otherwise the appliance will automatically trigger the
overheating protection after five successive cycles. The control lamps flash
and you cannot make any entries. The appliance is ready for use again after
around five minutes.