Silvercrest SMRS 35 A1 - Page 14

SilverCrest SMRS 35 A1
12 - English
In order to minimise any undesired sound reflections, a minimum clearance of 0.8 m behind and
aside of the speakers should be kept. You can check for any sound reflections by moving the
speaker closer and closer to a corner of the room. The bass component will raise the closer the
speaker is placed to the corner.
Negative sound reflection can also occur on the surface (shelve, chest of drawers, etc.) on which
the speaker is placed. There is already a difference in sound when placing the speaker on the front
edge of the furniture or in the centre of it.
Upon delivery, the sound is set for the installation conditions described above.
If you cannot find any location that meets the above requirements, you can still set the speaker
sound in order to optimise it for the given environment.
To do so, select the sound setting that best describes the location from the following list.
Location / application Recommended
sound setting
Effect
The speaker is standing freely at the
height of the listener's head, minimum
clearance to all walls 0.8 m
NORMAL Factory-default
configuration for optimum
location
- The speaker is standing
freely in a very large room.
BASS BOOST Slightly amplified bass
- The speaker is placed in a
corner or directly in front of
a wall.
- Wall-mounted speaker
LOW BASS Slightly attenuated bass
- The speaker is not at the
height of the head.
- The room is acoustically
attenuated by curtains and
carpets, for example.
TREBLE BOOST Slightly amplified treble
- The speaker is placed in a
room with large reflective
surfaces like windows,
plastered walls and tiled
floors.
- The speaker is placed in
the middle of a closet/table
LOW TREBLE Slightly attenuated treble
If you cannot obtain satisfactory results with the default sound settings, you can also adjust the bass
and treble manually.