The SilverCrest Mini Chopper SMZ 260 B1 is a versatile kitchen tool designed for processing small quantities of boneless foodstuffs and whipping cream. It is intended exclusively for private household use, emphasizing adherence to all safety instructions provided in the manual.
Function Description
The Mini Chopper is primarily used for chopping various boneless foodstuffs and whipping cream. It features a motor block with a turbo button for increased processing speed. The appliance operates by placing the food in a bowl, securing it with a lid, and then attaching the motor block. Pressing the motor block downwards initiates normal operating speed, while simultaneously pressing the turbo button engages a higher speed for more intensive processing.
For chopping, the appliance utilizes a blade holder with a sharp knife. Users are advised to cut larger pieces of food into smaller, approximately 2cm pieces, especially for hard foods, to prevent the motor from blocking. Pulsating processing (repeatedly pressing the turbo button for short durations) is recommended for hard foodstuffs. If contents accumulate on the bowl wall, the motor block can be lifted, the bowl shaken, and processing resumed.
For whipping cream, a whisk attachment is used. The whisk attachment is placed onto the blade holder. For 100ml of cream, it rests on two blades, while for 200ml, it is turned 180° to rest on a single blade, allowing it to plough higher through the cream. Cream should be well chilled (max 8°C) for optimal whipping results. Recommended whipping times are 30 seconds for 100ml and 30-50 seconds for 200ml at normal speed, though these can vary based on factors like fat content and ambient temperature.
Important Technical Specifications
- Mains voltage: 220-240 V~, 50 Hz
- Nominal power: 260 W
- CO Time (Continuous Operation): 1 Minute. After this period, the appliance must be switched off to allow the motor to cool down.
- Protection class: II / ⎕
- Capacity blender jug: 500 ml
- Max. capacity - Foodstuffs: up to the 350 ml marking
- Max. capacity - Liquids: 200 ml
Usage Features
Items Supplied:
The package includes the Mini Chopper, a blade holder with a blade, a whisk attachment, and operating instructions.
Appliance Components (Illustration A):
- Turbo button: Activates higher processing speed.
- Motor block: The main power unit.
- Lid collar: Connects the motor block to the lid.
- Lid: Secures the bowl during operation.
- Blade holder: Holds the knife or whisk attachment.
- Bowl: Container for foodstuffs.
- Knife: Sharp blade for chopping.
- Mounting: Point where the blade holder is placed.
- Appliance base: Provides stability and can also serve as a cover for the bowl.
- Whisk attachment: Used for whipping cream.
Operation Steps:
- Place the bowl (6) in the appliance base (9).
- Place the blade holder (5) with the knife (7) (or whisk attachment (10)) on the mounting (8).
- Prepare foodstuffs (cut into smaller pieces if necessary) and place them in the bowl (6), observing filling quantity limits.
- Close the bowl (6) with the lid (4) by aligning lugs and turning to lock.
- Place the motor block (2) on the lid collar (3).
- Press the motor block (2) downwards to start normal operation. For turbo speed, also press the turbo button (1).
- Once processing is complete, release the motor block (2) and unplug the power cable.
Safety Precautions:
- Always connect to properly installed power sockets (220-240 V, 50 Hz).
- Unplug the appliance immediately if faulty operation is noticed or before cleaning.
- Pull the plug, not the cable, to disconnect from the mains.
- Do not submerge the motor block in liquids or allow liquids to penetrate its housing.
- Never use the appliance outdoors or subject it to moisture.
- Do not grasp the appliance, power cable, or plug with wet hands.
- Do not open the motor block housing; repairs should be done by qualified specialists.
- Handle the extremely sharp blade with caution to avoid injuries. Keep the blade out of reach of children.
- Never attempt to remove foodstuffs from the bowl while the blade is still running. Wait until it stops rotating.
- Do not run the appliance for more than 1 minute at a time to prevent overheating.
- Observe filling quantities to prevent spillage.
Maintenance Features
Cleaning:
- Always unplug the appliance before cleaning.
- Do not clean the motor block (2) in a dishwasher; it should be cleaned with a well-pressed-out sponge.
- The motor block (2) and blade holder (5) with the blade (7) should be cleaned with a well-pressed-out sponge.
- The bowl (6), whisk attachment (10), lid (4), and appliance base (9) can be washed under running water and dried with a tea-towel.
- Alternatively, all components EXCEPT the motor block (2) are dishwasher-safe.
- Exercise caution when handling the sharp blade (7) during cleaning. Reassemble the appliance after cleaning to prevent injury from exposed blades.
Troubleshooting:
- Symptom: The Universal Food Processor will not switch itself on.
- Possible causes and remedies:
- Defective domestic electrical fuse: Check and replace fuses if necessary.
- Defective power socket: Try another power socket.
- Possibly defective universal food processor: Check the power cable and plug for damages. Arrange for the appliance to be checked by specialists.
Disposal:
- Do not dispose of the appliance in normal domestic waste. It is subject to European Directive 2002/96/EC.
- Dispose of the appliance through an approved disposal centre or community waste facility, observing applicable regulations.
- Dispose of all packaging materials in an environmentally friendly manner.
Warranty and Service:
- The appliance comes with a 3-year warranty from the date of purchase, covering material and manufacturing defects.
- Retain the receipt as proof of purchase.
- Contact the Service Department for warranty claims.
- The warranty does not cover transport damage, wearing parts, damage to fragile components, or damage from abusive/improper handling, use of force, or internal tampering.
- Repairs made under warranty do not extend the warranty period.
- Damage or defects existing at purchase must be reported immediately after unpacking.
- Repairs after the warranty period are subject to payment.
Need help?
General
To Next Page