Silvercrest SNIG 280 A1 - Appliance Description; Technical Details; Operation and Use; Filling the Appliance with Water

SNIG 280 A1■ 6
│
GB
│
IE
Appliance description
(For illustrations see the fold-out page)
Figure A
1 Water supply tank
2 Cap with water outlet
3 Tank holder
4 Power cable
5 On/Off switch
6 Nozzle
7 Holder for pads
8 Attachment
Figure B
9 Measuring cup
0 20 pads
Technical details
Power supply 220‒240 V
~
(AC), 50–60 Hz
Rated power 280 W
Protection class
II
(double insulation)
Tank capacity 1 95 ml
Operation and use
Filling the appliance with water
CAUTION! Fill the appliance only with distilled or purified water.
Never mix additives into the water! Use only the pads 0 for the aroma additives.
Note: Before the first use, there may already be some water in the tank 1 or in
the appliance. These are residues from test procedures in the production process
and do not represent a reduction in quality.
Distilled or purified water is usually available in supermarkets.
1) Make sure that the mains plug is not connected to a mains socket.
2) If inserted: Pull the tank 1 out of the tank holder 3. The lower edge of the
tank 1 protrudes slightly from the appliance. Lift the tank 1 out of there.