SPBH 3000 B2
■ 12
│
GB
│
IE
│
NI
CAUTION
► Use only a USB mains adapter with an output
voltage of 5 V and an output current of at least
2.1 A to charge the power bank.
► Use only the supplied charger cable
to
charge the power bank!
► Always disconnect the charger cable
when
charging is complete!
♦ Connect the USB plug of the charger cable
to
a suitable a USB mains adapter (not supplied).
♦ Connect the microUSB plug of the charging cable
to the microUSB charging port on the
Power Bank. An estimate of the charge level is
shown by means of the charge level LEDs .
LED display Charge level
One LED is flashing < 25 %
One LED is on,
the second LED is flashing
25 - 49 %
Two LEDs are on,
the third LED is flashing
50 - 74 %
Three LEDs are on,
the fourth LED is flashing
75 - 97 %
All LEDs are on 98 - 100 %
To Next Page
Loading...
