18 GB/IE/NI
Disconnecting product
manually from network
Press [4] for approx. 5 s until LED [5]
flashes.
This function only resets the product to
offline mode and starts the pairing mode.
If you want to remove all data from the
product and the cloud, refer to the chapter
“Additional functions”,
{
Disconnect and
wipe data
}
in the full instruction manual.
Overcurrent protection
The circuit breaker [7] interrupts the electric
current in case of overload or short circuit.
When the circuit breaker [7] trips:
– Remove the overload.
– Press the circuit breaker to reset.
Always leave enough clearance for the
circuit breaker to operate normally.
To Next Page
Loading...
Need help?
General
