Silvercrest SPUV 90 A1 - Setting the Alarm Time

Setting the alarm time
If the clock is set correctly, as described above:
1. Press the button AL1
y
resp. AL2
u
for 2 seconds. In the display
j
the
indicator for the alarm function resp. appears and the time indicator
blinks.
2. Press or hold the button HOUR
r
to set the hours.
3. Press or hold the button MIN
t
to set the minutes.
4. Press the button AL1
y
resp. AL2
u
once again. The programmed alarm
time will be taken over.
Radio alarm call
When the alarm time is set correctly, as described above:
1. Select and set the desired radio station, and the sound volume, with which
you wish to be woken (see also chapter Radio Operation).
2. Repeatedly press the button AL1
y
resp. AL2
u
until the symbol for radio
reception appears in the display
j
. At the programmed time the
radio will now switch itself on.
3. Press the button
o
to switch the radio off until the following day.
4. To deactivate the alarm function, repeatedly press the button AL1
y
resp.
AL2
u
until a symbol is no longer shown next to the indicator for the
alarm function resp. in the display
j
. After about 5 seconds the
device returns to just a time display and the indicator for the alarm
function disappears.
- 11 -