Need help?Do you have a question about the Silvercrest SPWG 180 G1 and is the answer not in the manual?
General| Brand | Silvercrest |
|---|---|
| Model | SPWG 180 G1 |
| Category | Scales |
| Language | English |
Remove the battery compartment strip. The bathroom scales are now ready for use.
Calibrate by stepping on/off briefly. Scales switch on automatically for weighing.
Scales have an automatic switch-off function after displaying the measurement result.
Open compartment, replace battery CR2032 with correct polarity, and close compartment.
Check battery: empty or inserted incorrectly. Refer to 'Replacing the battery' section.
Battery is almost empty. Replace the lithium battery CR2032 with a new one.
An error occurred. Step off the tread and step on again to restart the measurement.
Weight exceeds maximum load capacity (180kg/396lb). Step off immediately to avoid damage.
Do not dispose of used batteries in household waste. Take them to a collection point for old batteries.
For speedy claims, read documentation, call hotline, and have receipt/article number ready.
Provides phone numbers and email addresses for warranty and service support in various regions.
Contact address for TARGA GmbH, the manufacturer of the bathroom scales.
To Next Page