To Next PageTo Next PageWhat to do if my Silvercrest Clock Radio has no sound?
If your Silvercrest Clock Radio has no sound, there might be a couple of reasons. First, make sure the device is switched on by pressing the / AMS button. Also, check that the volume isn't set too low; increase it using the VOLUME/ HOUR ?/+ dial.
How to fix Silvercrest SRWK 800 A1 when there is nothing on the display?
If there is nothing on the display of your Silvercrest Clock Radio, first ensure the device is switched on by pressing the / AMS button. Check that the mains cable is correctly connected to a mains socket and that the mains socket is supplying power by checking the house mains fuse. Also, note that in standby mode, the display is automatically switched off between 11 pm and 4:59 am (night mode); this is not a technical error.
Why does my Silvercrest SRWK 800 A1 Clock Radio reset after a power failure?
If your Silvercrest Clock Radio resets the time, date, and station presets after a power failure, it's likely due to the batteries. Ensure that there are batteries in the battery compartment and that they have sufficient charge; replace them if necessary. Also, verify that the batteries are inserted correctly in the battery compartment, following the polarity diagram.
How to improve radio reception on my Silvercrest SRWK 800 A1 Clock Radio?
If you're experiencing interference with the radio reception on your Silvercrest Clock Radio, it could be due to weak radio reception. Try completely unwinding the wire aerial. Improve reception by moving the wire aerial or setting up the radio in a different location.
What to do if my Silvercrest Alarm Clock has no sound?
If your Silvercrest Alarm Clock has no sound, there might be a couple of reasons: * The device might not be switched on. To solve this, switch on the device by pressing the / AMS button. * The volume might be set to the minimum. In this case, increase the volume using the VOLUME/ HOUR dial.
Why is there nothing on the display of my Silvercrest Alarm Clock?
If there is nothing on the display of your Silvercrest Alarm Clock, here are a few potential causes: * The device is not switched on. Solution: Switch on the device by pressing the / AMS button. * The mains cable is not connected correctly. Solution: Make sure that the mains cable is correctly connected to a mains socket. * The mains socket is not supplying any power. Solution: Check the house mains fuse. * In standby mode, the display is automatically switched off between 11 pm and 4:59 am (night mode). This is normal.
Why does my Silvercrest Alarm Clock reset the time and date after a power failure?
If your Silvercrest Alarm Clock resets the time, date, and station presets after a power failure, it's likely due to the following: * There are no batteries in the battery compartment or the batteries are dead. Check that the batteries have sufficient charge and replace them if necessary. * The batteries are inserted incorrectly in the battery compartment. Check that the batteries are inserted correctly, following the polarity diagram.
How to fix interference with radio reception on my Silvercrest Alarm Clock?
If you are experiencing interference with the radio reception on your Silvercrest Alarm Clock, it could be due to weak radio reception. To improve this, completely unwind the wire aerial. Try moving the wire aerial or setting up the radio in a different location.
General| Brand | Silvercrest |
|---|---|
| Model | SRWK 800 A1 |
| Category | Clock Radio |
| Display Type | LCD |
| Alarm Function | Yes |
| Radio Type | FM |
| Preset Stations | 20 |
