- 5 -
Filling when in use
Warning!
Should you wish to insert further foodstuffs during
operation, you may ONLY open the filling cap
q
provided for this purpose.
• Under no circumstance should you open the lid
w
. Pieces of the foodstuff could be thrown out at
high speeds!
• Do not insert cutlery items or mixing tools into
the mixing jug
e
when the appliance is in use.
There is a considerable risk of injury should these
make contact with the swiftly rotating cutters
r
!
To insert something when the appliance is in
operation, ...
➩
turn the filling cap
q
anti-clockwise and remove
it.
➩
Fill in the ingredients.
➩
Afterwards, replace the filling cap
q
into the
lid and secure it by turning it clockwise.
Removing the mixer
When the processing of the foodstuffs is complete:
➩
Always first place the switch
t
into the OFF
position ("0") and remove the power plug.
➩
Wait until the motor has come to a complete
standstill before lifting the mixer jug
e
straight
up. It does not need to be turned.
Useful tips
– The best results when blending firm ingredients
are achieved by placing small portions one after
the other into the mixer jug
e
instead of inser-
ting a single large portion.
– When processing firm ingredients, cut them into
small pieces (2-3 cm).
– When mixing liquid ingredients begin first of all
with a small measure of fluids. Gradually add
more fluids to the mixture through the filling cap.
– The appliance can be stabilised by placing your
hand on top of the closed liquidiser during opera-
tion.
– For the stirring of firm or very viscous foodstuffs
it can be beneficial to use the impulse-operation,
which helps avoid a blocking of the cutters
r
.
Notice
Do not use the appliance to crush grains of cooking
salt, refined sugar or white sugar. For example, to
make powdered sugar.
IB_71495_SSM550B1_LB7 21.10.2011 10:54 Uhr Seite 5
To Next Page
Loading...
