Silvercrest SSVM 40 B2 - Assembly; Height Adjustment; Tilt Adjustment

18 GB/IE
 Before use
 Unpacking
 Remove the packaging. Check if the product is
damaged.
 Assembly
 Accessory needed: Cross head screwdriver
 Number of persons needed for assembly: 1 adult
Fig. Step
C
1. Turn the extension pole [] upside down
so that the L-shaped bolt [] is directed
upwards.
2. Remove the L-shaped bolt [] and the
washer [] from the extension pole [].
3. Place the base [] and the base
weight[] on the extension pole [].
4. Fasten the washer [] and the L-shaped
bolt [].
D
1. Turn the assembled parts from the previous
assembly step upside down. Place the
base[] on the floor.
2. Loosen the lock screw[] from the
extension pole[].
3. Place the motor unit’s[] upper pole on
the extension pole []. Align the hole
on the back side. Tighten the lock screw
(motor bracket)[].
E
Remove the lock screws (M5x8mm) (x 4)
(rear grille) [] from the motor unit [].
F
1. Align the grille handle [3] upwards and
to the rear. Attach the rear grille [2] to the
motor unit (with upper pole) [].
2. Tighten with the 4 lock screws [].
G
Point the groove on the motor shaft [4]
upwards.
Fig. Step
H
1. Loosen the lock screw [] from the
blade [1] (the lock screw is pre-assembled
on the blade’s screw thread).
Place the blade on the motor shaft[4] (the
blade’s rear with the lock screw is facing
the motor unit (with upper pole)[]).
2. Tighten the lock screw (M4x8mm)
(blade) [].
I
1. Open the grille clips (x 5) [] on the front
grille [].
2. Remove the lock nut and lock screw
(M2.5x10mm) (grille) [] from the front
grille [].
3. Hang the grille hanger [] of the front
grille [] on the rear grille [2].
NOTE: The grille clips (x 5) [] must fit
over the frame of the rear grille [2].
J
Insert the lock screw []. Fasten the lock
nut []. Close the grille clips (x 5) [] at the
grille frame.
 Height adjustment
 Loosen the height adjustment knob []
(positioned on the extension pole []) in a
counter-clockwise direction.
 Adjust the length of the extension pole [].
 Tighten the height adjustment knob [] in a
clockwise direction.
 Tilt adjustment
 Loosen the knob (tilt adjustment) [9].
 Adjust the tilt angle manually.
 Tighten the knob (tilt adjustment) [9] again.
 Do not perform the tilt adjustment when the
product is in operation.