5
GB
WARNING! Risk of material
damage
~ Never place the device on hot surfaces
(e.g. hob plates) or near heat sources or
open fire.
~ Only use the original accessories.
~ Do not use any astringent or abrasive
cleaning agents.
4. Items supplied
1tower fan|1
1 base (consisting of 2 parts)|8
1screw
1 set of operating instructions
Unpacking
1. Remove all parts from the packaging.
2. Check that all parts are present and in-
tact.
5. Assemble appliance
Before the device can be used, the base|8
must be screwed on:
1. Figure A: put the rear half of the
base|10 and the front half of the
base|11 together. Ensure that the con-
nection audibly clicks into place.
NOTES:
• The rear half of the base|10 can be
identified by the recess for the mains
power cable|9.
• Ensure that the mains power cable|12 is
lying in the recess for the mains power ca-
ble|9.
2. Figure B: place the tower fan|1 on
the base|8. Ensure that it is standing
safely, and that the mains power ca-
ble|12 is lying in the recess for the mains
power cable|9.
3. For safety reasons, screw the tower
fan|1 firmly onto the base|8. For this
purpose, use the screw supplied.
4. Select a location which complies with
the safety instructions (see “Safety infor-
mation” on page 3).
5. Insert the mains plug|12 into a mains
socket corresponding to the technical
data.
6. Operation
6.1 Start and switch off the
appliance
1. Plug the power plug into a power sup-
ply socket which meets the technical
data requirements.
2. Switch on the power
supply by turning rota-
ry switch|2 to ON.
The appliance is now
operational.
3. Switch off the power
supply by turning rota-
ry switch|2 to OFF.
__CPE282343_TowerVentilator_B4.book Seite 5 Mittwoch, 7. Dezember 2016 8:39 20
To Next Page
Loading...
