SilverCrest STVM 30 B2
6 - English
• If liquid does penetrate into the device, disconnect the power
plug immediately. Get the product checked by an expert before
using it again.
• Never operate the product with wet or damp hands.
• Do not touch the product if it is in water or another liquid,
instead, pull the plug from the mains socket.
• Do not use the product if the power plug or the power cable is
damaged, if it does not work properly, if it has fallen into water,
been dropped, or if it showing any other signs of damage. In
this case, please consult an expert to repair the product.
• Only connect the power cable to a properly installed, easily
accessible mains socket whose mains voltage corresponds to
that in the ”Technical specifications” chapter. No action is
required by the user to set the product to 50 or 60 Hz. The
product automatically adjusts to 50 and to 60 Hz. The mains
socket must also be easily accessible after connecting.
• Make sure that the power cable cannot be damaged by sharp
edges or hot spots.
• When using the product, make sure that the power cable is not
jammed or squashed in any way.
• Even when switched off, the product is not entirely disconnected
from the mains power. Pull the power plug to disconnect it
completely. Always pull on the power plug, not the cable.
• Unplug the power plug from the mains socket
o if a problem occurs,
o if you are not using the product,
o for installation,
To Next Page
Loading...
Need help?
General
