English – 11
WARNING!
The device contains live parts. They pose a risk of
electric shock or fire if an unintentional short circuit occurs.
Never
open the device housing and do not push objects inside the device
through the slots and openings!
Only connect the device to a properly installed, earthed mains
socket that is easy to reach and close to the place where you have
set up the device. The mains voltage must match the technical speci-
fications for the device.
Always keep the power socket free of obstructions so that the plug
can be pulled out easily.
Always unplug the mains adapter from the power socket before
cleaning.
When unplugging the mains cable from the socket, always pull on
the plug rather than on the cable.
In the event of damage to the mains adapter or if liquids or foreign
bodies get into the device, remove the plug from the power sock-
et immediately.
In an emergency, for example, if you see smoke coming out of the
device or if it makes unusual noises, immediately remove the mains
plug from the power socket.
Only use the device indoors in dry rooms.
To prevent the device from falling, only install and operate it and its
components on a sturdy, level and vibration-free surface.
During the set-up process, maintain a minimum distance of 5 cm
around the device for sufficient ventilation.
Ventilation must not be impeded by covering the device with objects
such as mag azines, table cloths, curtains, etc.
Do not place the device near direct heat sources (e.g. radiators)
that could affect it.
Do not place naked flames (e.g. lit candles) on or near the device.
Do not place containers filled with liquid, e.g. vases, on or near the
product, and protect all the parts from drips or splashes. Such con-
tainers may tip over and the liquid may impair the electrical safety
To Next Page
Loading...
