SilverCrest SURF 600 A1
34 - English
Setting the date / time
Setting automatically via radio signal
The radio alarm clock is fitted with a radio-controlled time display. The date and time is set automatically
after the device is initially connected to the mains. Three bars "- - -" on the display (11) indicates that the
radio alarm clock is waiting for the radio signal for the date and time. After the radio signal is received,
the current time will be shown on the display (11). In off mode, press the "Display" button (3) once, to
display the day and month. Press the "Display" button (3) a second time to display the year. After approx.
five seconds, the display returns to the current time.
It can take a few minutes for the device to find the radio signal. If during this time no radio signal is found
to set the time, you can start the search again by following the steps below:
In off mode, press and hold the "SET/MEMORY" button (7) for approx. two seconds until the display
indicator changes from the current time to "rcc".
Whilst "rcc" is shown on the display (11), press the multi-function controller (1). The "- - -" icon on the
display (11) signals that the search for the radio signal is active.
You can also specify whether the time should be checked and readjusted every 24 hours via the radio
signal:
In off mode, press and hold the "SET/MEMORY" button (7) for approx. two seconds until the display
indicator changes from the current time to "rcc".
Whilst "rcc" is shown on the display (11), turn the multi-function controller (1). You can choose either
"ON" or "OFF".
"ON": The time will be calibrated via the radio signal every 24 hours.
"OFF": The time will not be calibrated automatically.
The device is supplied in „ON“ mode.
The "- - -" icon on the display (11) means that the search for the radio signal is active.
If there is high-frequency interference or poor reception conditions e.g. in well shielded
buildings, reception of the DCF time signal transmitter may be limited or not possible at all.
In this instance you can set the time manually, as described in the following section.
Setting the time manually
In addition to setting the clock automatically, it is also possible to set the time manually. This can be useful
when, for whatever reason, the radio signal cannot be detected:
To Next Page
Loading...
