8
SWC 300 B1
GB
Removing attachments
■ First switch the appliance off and allow it to cool down..
■ Pull the attachment from the attachment insertion slot 1.
Switching on/off / Selecting a heat level
■ When you have inserted the required attachment and connected the plug
with the mains power socket, you can now switch the appliance on with the
level switch 3 and select the output level:
– "0" The appliance is switched off
– "C" for a cold air stream (Cool Shot)
– "1" for a warm air stream
– "2" for a hot air stream
■ You switch the appliance off by sliding the level switch 3 to the position "0"
(= appliance off ).
■ To fi x the styling, you can move the level switch 3 to "C". The styling will be
fi xed by the cool air stream.
Styling
Select the desired attachment:
– for long hair and large curls the large styling brush 4.
– for shorter hair or small curls the small styling brush 8.
■ Wind the slightly damp strand of hair around the selected styling brush 4/8.
■ Switch the appliance on at level 1 or 2.
■ When the strand is dry, slide the level switch 3 to "C". Wait until the strand
has cooled.
■ Press the roll-out button 2 and simultaneously pull the appliance downwards
out of the strand. The styling brush 4/8 rotates with it, so that unwinding
the strand can be done easily.
■ Proceed with the other strands in the same way.
To Next Page
Loading...
