8
GB
Symptom Possible Cause Solution
No detergent suction Lance not in low pressure mode Change setting with trigger released
Smoke Overloaded or damaged motor Do not use. Contact dealer immediately
Pressure washer doesn’t start
Pressurized Squeeze trigger on gun before starting
Mains plug not fully inserted or mains socket switch is off Check and correct issue
RCD has operated or
not been reset
Reset RCD
Plug fuse has blown Replace fuse and contact dealer if it immediately blows again
Thermal safety switch has operated Switch off and allow pressure washer motor to cool before starting
Poor water spray pressure
Water inlet filter is clogged Clean filter
Water hose connection is leaking or allowing air to enter Check water hose connection
Pressure washer valves or seals are worn or damaged Contact dealer
Fluctuating water pressure
Pump is sucking in air Check water hose connections
Clogged nozzle See Maintenance for cleaning procedure
Motor stops suddenly Thermal safety switch has operated Switch off and allow to cool before restarting
Water leaking from pump Seals worn out Contact dealer
Troubleshooting
Maintenance
Cleaning
• Keep your machine clean at all times
• Always allow all water to drain from the pump before storing
• The Lance Nozzle may become dirty or blocked over time, which will
effect operation. Clean the lance nozzle using the Cleaning Pin (6)
supplied. A garden hose can also be used to clean the nozzle by back-
flushing water through the nozzle. Combining use of the pin and back-
flushing should enable the nozzle to be fully cleaned. The frequency of
doing this will depend on the water quality in your area with hard water
areas requiring more frequent cleaning
• Regularly check the Water Inlet Connector (18) filter to make sure it is
clear
Storage
• Always store this machine in a dry place that will not fall below 0˚C
Disposal
Always adhere to national regulations when disposing of power tools that
are no longer functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic
equipment (WEEE), with household waste
• Contact your local waste disposal authority for information on the correct
way to dispose of power tools
102377_Z1MANPRO1.indd 8 06/11/2013 09:58
To Next Page
Loading...