To Next PageTo Next PageWhat to do if my Silverline SDS Plus 1500 W will not start?
If your Silverline Drill won't start, it could be due to a blown fuse. Check and replace the fuse. If the problem continues, it is possible that the power cable is damaged, the ON/OFF trigger switch is faulty, or the motor is faulty. For these issues, it's best to contact an authorized Silverline service center for assistance.
Why is my Silverline SDS Plus 1500 W vibrating or making abnormal noises?
If your Silverline Drill is experiencing vibration or making abnormal noises, it could be due to low grease in the gearbox. Try adding or replacing the grease. Alternatively, excessively worn internal moving parts might be the cause. In this case, you should contact an authorized Silverline service center.
Why does my Silverline SDS Plus 1500 W Drill have slow rotation speed and visible sparking?
If your Silverline Drill has a slow rotation speed or no rotation and you see sparking from the motor vents, the carbon brushes are likely worn. You can replace the brushes yourself, or contact an authorized service center to have them replaced.
What to do if Silverline SDS Plus 1500 W core drill has locked/jammed in the material?
If your Silverline Drill's core drill gets locked or jammed in the material while core drilling, it might be due to excessive pressure on the tool at the point of breakthrough. Reduce the pressure before breakthrough. It could also be that the core drill is not suitable for the drill, so use a compatible core drill accessory. A large build-up of debris inside the core drill while operating can also cause this issue; regularly empty the debris to ensure safe operation.
Why does my Silverline SDS Plus 1500 W Drill have a slow rotation speed?
If your Silverline Drill has a slow rotation speed, it may be overheating. Switch the tool off and allow it to cool down to room temperature. Inspect and clean the ventilation slots.
General| Brand | Silverline |
|---|---|
| Model | SDS Plus 1500 W |
| Category | Drill |
| Language | English |
Symbols indicating personal protection, operational safety, and environmental compliance.
Comprehensive safety guidelines for operation and maintenance.
Procedures for fitting SDS accessories, keyed chuck, and auxiliary handle.
How to adjust the tool's speed using the variable control for optimal performance.
Guide to selecting hammer, rotary, chisel modes and drilling concrete, wood, metal.
Procedures for gearbox greasing, cleaning, and brush replacement.
Solutions for common issues like jamming, tool not starting, slow speed, and vibration.
Instructions on how to register the product for the 3-year guarantee.
Details of what the guarantee covers, what it excludes, and battery guarantee.
