SYSTEM OPERATIONS-18
The left hand side are all the switches
connected to battery #1. The right hand
side are all the switches connected to Bat-
tery #2.
The switches for the left column (BAT-
TERY #1) are (from top to bottom):
---DC Main #1: Supplies 12 Volt Power
from Battery #1 to all breaker switches
directly under this switch.
---Accessory-Supplies the power to the
Helm Switches.
---Cabin Lights Forward: Supplies power
to the cabin lights in the forward stateroom
and forward head.
---Cabin Lights Galley: Supplies power to
the cabin lights in the galley.
---Aft Toilet: Supplies Power to the aft
toilet.
---Aft Shower Pump: supplies power to the
Aft Shower Sump Pump.
---Refrigerator: Supplies DC Power to the
refrigerator.
---Fresh Water: Supplies power to the
fresh water pump.
---SPARE: Can be used for any DC pow-
er.
---Port Controls: for the optional port en-
gine control system.
The switches for the right column (Battery
#2) are (from top to bottom):
---DC Main #2: Supplies 12 Volt DC power
from Battery #2 to all breaker switches
directly under it.
---Courtesy-
---Cabin Lights Aft: Supplies power to the
aft stateroom main lights.
---Engine Room Lights-Supplies power to
the lights in the Engine Room.
---Forward Toilet: Supplies power to the
forward toilet.
---Forward Shower Pump: Supplies the
power to the shower sump pump.
---Macerator: Supplies power to the Mac-
erator pump.
---Autopilot: Supplies power to the optional
Autopilot.
---Accessory: Can be used for any DC
Power.
---Starboard Controls: Supplies power to
the optional starboard engine control.
Located in the lower section of the DC
Volt section of the AC/DC Panel is the
Bilge Pump section of the AC/DC Panel.
There are three (3) sets of breakers and
switches. Each bilge pump (forward, mid,
and aft) has a reset breaker switch (right)
and an ON/OFF Switch (left). Although the
bilge pumps always have power to them,
to operate the bilge pumps manually, you
must have the battery switches “ON”.
BREAKER SWITCHES (right switches):
The breaker switches are your safety
switches. They work just like a fuse, but
are resetable. If the breaker switch is ac-
tivated, before resetting the switch, locate
the problem. The breaker is reset by push-
ing in the white button.
MANUAL SWITCH (left switches): This is
the “ON/OFF” Switch for manual operation
of the bilge pumps.
To Next Page