Why my Sima STP-1000T Inverter does not operate?
If your Sima Inverter isn't operating, it could be due to a couple of reasons. First, check that the input voltage is not below 10 volts; if it is, attach the inverter to a proper power supply. Also, a blown fuse could be the culprit. If the fuse is blown, determine what caused it to blow and then replace it.
What to do if the low battery alarm is on for Sima STP-1000T Inverter?
If the low battery alarm is on for your Sima Inverter, it typically means the input voltage is below 10.2 volts. To resolve this, ensure that your car engine is running. Also, check the condition of the wiring. The battery itself might be low and require recharging.
Why does my Sima STP-1000T Inverter operate for a short period and then turns off?
If your Sima Inverter operates briefly and then shuts off, it's likely due to the load trying to draw too much current. Ensure the load is less than the inverter's rated wattage. Remove any excessive load, then turn the inverter off and back on to reset it.
What to do if Sima Inverter operates for a while and gets warm?
If your Sima Inverter operates for a while and gets warm, it may be in thermal shutdown mode. To fix this, allow the inverter to cool down, then turn it off and back on to reset it.
How to stop television and stereo interference from Sima STP-1000T?
If you're experiencing television and stereo interference with your Sima Inverter, it's likely due to RF interference from the power inverter. Try positioning the power inverter and its wiring as far as possible from electronic equipment, antennas, and cables, and reorient as necessary.
Why 115 VAC output voltage reads incorrectly on Sima Inverter?
The modified sine wave output from your Sima Inverter can cause incorrect readings on a typical multimeter. Use a true RMS meter like a Fluke 8060A or Triplett 4200 to measure the correct voltage.
Details on how to securely mount the power inverter, emphasizing ventilation and location.
Step-by-step guide for wiring the inverter to the electrical system and fuse block, including safety precautions.
Guidelines on selecting appliances that do not exceed the inverter's power rating.
General| Input Voltage | 12 V DC |
|---|---|
| Output Voltage | 110V AC |
| Continuous Power | 1000 W |
| Surge Power | 2000 W |
| Output Frequency | 60 Hz |
| Output Waveform | Modified Sine Wave |
To Next Page
