Simac PastaMatic MX700 - Assembly Instructions; Step 1. Place the base; Step 2. Insert the rotary screw; Step 3. Grasp the shutter slide

Assembly Instructions
Here you will learn to assemble (and disassemble) the machine
properly.
· Step 1.
Place the base on a clean, dry surface near an electrical outlet, with the
logo facing you.
Slide the rotary housing all the way into the open side of the base,
ridged side down and rectangular opening facing up.
· Step 2.
Insert the rotary screw, metal end first, all the way into the rotary
housing.
It will be necessary to rotate the screw for it to fit in completely. The
end of the screw should be flush with the end of the rotary housing.
· Step 3.
Grasp the shutter slide, and firmly push it all the way into the slot over
the rotary housing. It will click in place.
· Make sure slide is fully in place before adding any ingredients.
Look down inside the bowl to make sure the slide completely covers
the opening in the bottom of the bowl. The slide must remain clos
securely in place during the mixing cycle to avoid ingredients from
entering the rotary housing prematurely, clogging and possibly
damaging it.
ed
· Step 4.
Insert the bowl onto the base, matching the notch on the top edge of the
bowl with the tab of the opening located towards the front of the base,
and pressing down firmly.