12
3rd SECTION
INSTALLING YOUR DEEP FREEZER AND FIRST OPERATION
1. Air circulation should be ensured at the rear area of the deep freez-
er for ecient use. At least 20 cm gap should be allowed at lateral and
rear sides of your deep freezer.
2. Do not expose the product to direct sunlight or keep in damp en-
vironments.
3. Place the product on a at surface to avoid vibration.
4. If you operate your deep freeze in conditions below 10°C or over
43°C, the functionality may not be at the desired level.
5. After completing installation, allow at least 2 hours without moving
your product. Then, plug it into plug socket.
Electrical Connection
Our rm will not assume responsibility for any damages due to usage
without earthing and power connection in
compliance with national regulations.
• Do not use multi-group plug with or without extension cable be-
tween the wall socket and the refrigerator.
• Connect your refrigerator to a 220-240V /50 Hz grounded mains
socket. The socket must include a 10-16A fuse.
The voltage and frequency of mains power should be the same
as the values specied on the label on the inner surface of your
appliance. If mains power is far below or above the specied
value, have the desired voltage by using a voltage regulator. You can
get help from a qualied electrician. The fuse of the mains socket
should be maximum 16A.
!
To Next Page
Loading...
