Simmons sd1000 kit - Page 3

Wing Nut
Felt Washer
4
Wing Nut
Felt Washer
3
Loosen wing screw on drum rack.
Place drum module into drum clamp.
Tighten wing screw to secure module.
3
1
2
Attaching the drum module
Attaching Cymbals
Insert each cymbal arm into the rack
clamp.
Insert short hi-hat arm on the left-side
arm’s cymbal clamp.
Remove wing nut and felt washer from
cymbal tilter. Place cymbal pad on tilter
assembly.
Re-attach the felt washer and wing nut.
Tighten wing nut.
1
2
3
4
1
1
2
3
www.simmonsdrums.net
Tilter
Simmons_SD1000_Assembly_Instructions.indd 3 5/9/13 3:24 PM