MRMap Development Team 14/01/2009
As a result of a meeting held at Keswick MRT HQ on 6th September 2005, this document has
been produced in order that information presented at the meeting but considered too detailed
for inclusion in the minutes, might be passed on to all interested parties. It is not pitched at
any presumed level of understanding and some things are explained even though
they may be obvious to all. Conversely, anything that’s not obvious can be ex-
plained in greater detail, by one or more of the contributors.
The sections included have come from the team responsible for developing the device or con-
cept and the author is responsible only for graphics and writing up or collation of the various
documents.
All re-broadcast devices are based upon current Simoco radio equipment and thanks are due
to Team Simoco Ltd in Derby and Huntingdon, and TMC Radio Pty Ltd in Australia for their
help in resolving issues that arose during the construction of these devices.
In the majority of cases, the wiring associated with power supply, speakers and aerial connec-
tions are not shown in order to help with clarity. In the case of speakers, this is a local deci-
sion as to whether they are used. They are not strictly necessary to the functioning of a re-
broadcast or repeater device but one will be required if the ‘Standard’ variation is adopted as
one of the radios forms the normal comms set for the vehicle when it’s not in re-broadcast
mode.
With thanks to :-
Bowland Pennine MRT
Coniston MRT
Duddon & Furness MRT
Kendal MRT
Keswick MRT
Moffatt MRT
Penrith MRT
Roger Taylor, Tower Communications
Team Simoco Ltd
TMC Radio Pty Ltd
Tom Taylor ARCC Kinloss
To Next Page
Loading...
