SRP9170/80 P25 Portable Radio – User Manual
© ComGroup Australia 2010 Page 62 TNM-U-E-0091 1.4a
RF Exposure Compliance and Control Guidelines and
Operating Instructions
To control exposure to yourself and others and ensure compliance with the Occupational/ Controlled
environment exposure limits always adhere to the following procedures.
Guidelines:
User awareness instructions should accompany the device when transferred to other users.
This radio meets the FCC RF exposure guidelines when used with the Simoco accessories
supplied or designated for the product. The designated Simoco belt clip type is PAR-
9180CLIP and leather pouches for bodyworn use are Simoco types PAR-9180CLBC2 and 3,
and PAR-9180CHSM. These pouches can be used with audio extension speaker microphone
type PAR-9180LMS2 and microphone with antenna type PAR-9180LMR4. Use of other
accessories may not ensure compliance with the FCC’s RF exposure guidelines and may
violate FCC regulations.
Do not use this device if the operational requirements described herein are not met.
Instructions:
Transmit no more than the rated duty factor of 50% of the time. To transmit (talk), push the
Push-To-Talk button. To receive calls, release the PTT button. Transmitting 50% of the time,
or less, is important because this radio generates measurable RF energy exposure only when
transmitting (in terms of measuring for standards compliance).
Do not operate the radio without an approved antenna attached, as this may cause the FCC
RF exposure limits to be exceeded. With this product, use only an antenna supplied or
approved by Simoco.
Always keep the radio at least 5 cm (2.0 inches) from the face when transmitting and at least
10 mm (0.4 inches) from the body. This radio has been tested for RF exposure compliance at
the distances listed in Table 1.
To Next Page
Loading...
Need help?
General
