GAS LEAK TESTING
It is important that you leak test the BBQ before first use and every time the gas
cylinder is refilled and reconnected to the BBQ.
To complete a Leak Test:
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
Mix the solution well (about the same concentration as washing up water).
• Turn the cylinder ON by rotating the knob to the open position.
• Using a brush or spray bottle apply the soap solution to the gas line and each
join in the gas line including:
• The gas connection at the inlet of the BBQ
• All gas hose connections
• The gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the
connection DO NOT PROCEED.
• Replace gas hose and regulator.
• Replacement hose and regulators can be purchased from your local BBQ
retail specialist
Read Me First
Page 2
To Next Page
Loading...