Simon XTi Quick Guide
https://alpha.adt.com/help/281[11/28/2018 12:28:27 PM]
For more information on this topic, please view the Simon XTi manual.
Reset
It is recommended that you clear the system status after an alarm event.
To clear and reset the system status, select the [STATUS & SETTINGS] button on the home screen.
Select the [CLEAR] button located next to the [Panel Status] button.
Select the [CLOSE] button to exit through the menus back to the home screen.
For more information on this topic, please view the Simon XTi manual.
Security Codes
You can program up to 8 different security codes for use by other users, however only the Master user
can assign user codes to users. No user, except for the Master user, can program or bypass sensors.
To add a user code:
Select the [STATUS & SETTINGS] button from the home screen.
Scroll until the [Programming] option is listed. Select the option by pressing the [Programming]
button or pressing [Enter].
Enter your [master security code], then press [OK].
Select the [ACCESS CODES] button. Initially all user codes are blank.
Use the white field next to the access code to enter a new access code or to edit/delete a current
access code, then press [SAVE].
For more information on this topic, please view the Simon XTi manual.
Trouble Conditions
Your security system is able to automatically test itself for power failures, low batteries, nonworking
sensors, and communication troubles with the central monitoring station. When your security system
detects a trouble condition, six rapid beeps will sound every minute for four hours until the trouble
condition is corrected.
To silence trouble beeps, press [STATUS] or arm/disarm the system.
For more information on this topic please visit the Simon XT Troubleshooting
page.
Volume
To program the beep volume:
To Next Page
Loading...
Need help?
General