37
ENGLISH
2. Enabling the software block to enter the
dose programming function.
Use the 1 long coffee key
to enable a
software block to programme doses (key lit) or
to de-activate the block.
3. Adjusting keypad brightness.
The 2 long coffees key , which will
flash, is used to choose the key brightness set-
ting from 5 pre-set levels.
Use the key
to change the level, low-
ering it to minimum or returning it to maximum.
Press the continued key
to exit the
programming function and return to the dose
programming function.
The page for setting operating parameters is
opened by pressing the
key together
with the 2 espresso key
while no
delivery is enabled:
1. Enabling the pump if the level is enabled.
2. Enabling the software block to enter the
dose programming function.
3. Adjusting keypad brightness.
1. Enabling the pump during levelling.
Use the 1 espresso key
to set pump
enabling during levelling:
if the key
is lit, the pump is enabled
together with the level; if it is switched off, the
pump is not enabled with the level function.
7.6
PROGRAMMING
OPERATING
PARAMETERS
The adjustments listed here below must
ONLY be performed by a Specialist Technical
Engineer.
CAUTION
Use the relevant procedure to enter the pro-
gramming function.
To Next Page
Loading...
