TROUBLESHOOTING
EN
Problems Causes Solutions
The machine does not switch on.
Pilot light
OFF after pressing the main
switch
.
»
The machine is not connected to the
power source.
» Connect the machine to the power source.
» Contact customer service.
The machine requires a lot of time to
heat up.
»
Machine affected by limescale deposits.
» Descale the machine.
The pump is very noisy.
» There is no water in the tank.
» Fill-up with fresh drinking water.
The loading lever doesn’t reach the
brewing position.
» Spent capsule drawer filled.
» Capsule fitted incorrectly.
» Empty the spent capsule drawer.
»
Repeat the sequence, lever in the off position, lever
in the brewing position; if this is not enough, operate
manually to remove the capsule from the duct with
the machine disconnected from power mains.
The coffee is brewed too fast, the brewed
coffee is not creamy.
» Spent capsule. »
Bring the lever back to rest position and load a new
capsule.
Coffee not supplied and steam coming
out of the capsule compartment.
»
The loading lever was not set to the
brewing position.
» Set the loading lever to the brewing position.
Coffee is not brewed or brewed in drips
only.
» Dispensing spout is clogged.
» Clean the dispensing spout.
TECHNICAL SPECIFICATIONS
• Nominal Voltage - Power Rating - Power Supply:
See the plate placed on the machine
•
Dimensions: Height Width Depth
12” (305 mm) 9.25” (235 mm) 13” (330 mm)
• Weight: about 11 lbs. (5 kg)
• Water tank: 30,5 oz. (0.9 litres) - Removable type
• Housing Material: ABS - Thermoplastic
• Power Cord Length: 47” (1.2 m)
• Control Panel: Top of machine
• Thermal fuse
• Aluminium flash boiler with temperature probe
Client Service Lavazza A Modo Mio
0800 599 9200
Fax. +44 (0)1895 209 778 e-mail: info@lavazzamodomio.co.uk
To Next Page
Loading...