caution
• Disconnect power before installation.
• Product shall be installed by qualified
electrician or person who is familiar
with the product.
• If either cord is damaged, please return
product to manufacturer immediately.
Do not try to replace cord.
• Use only indoors.
• Do not submerge in water.
• Do not mount in wet environments.
• Do not disassemble.
• For use on the wall only.
In a few easy steps,
we’ll show you how to
hard-wire and mount
your sensor mirror to
the wall.
sensor mirror
ST3003 (100-240V, ~ 50/60 Hz, 10W)
Attention: Please read instructions
before using.
To Next Page
Loading...
