3. Handling
The sIMPLEk includes 3 operation modes:
[1] 1:1-Modus
[2] Tuningmode
[3] Calibrationmode
A change from one operating mode to another is achieved if in each mode the e-bike is switched off immediately
after the start and then waited at least 5 seconds and then restarted.
Attention!
E-bikes without a display or speedometer: In this case, no calibration is necessary. When using the
module for the first time, you must inform the module that there is no display by driving off immediately or spinning
the rear wheel.
Attention! BROSE engines:
When changing the operating mode, it is necessary to switch the e-bike to deep
sleep mode when it is switched off. This is achieved by holding down the power button on the control unit or on the
battery for at least 3 seconds. With some firmware versions, switching off to deep sleep mode can only be achieved
by briefly removing the battery. This also applies to the switch-off processes during calibration.
Attention! Bosch Gen4 engines:
We strongly recommend running the automatic route compensation
after each trip to counteract the "anti-tuning measures".
Tabelle – Wechsel zwischen den Betriebsmodi
[1]
Switch off
immediately after
start and min.
Wait 5 seconds
[2]
Switch off
immediately
after start and
min. Wait 5
seconds
[3]
Performance or
cancellation of
the calibration
[1]
[2]
no restart
immediately
after the start
[1]
[1]
no restart
immediately after
the start
[1]
To Next Page
Loading...