3.1. 1:1-Mode
After the E-Bike will be running longer than 15 second in the tuning-mode or 1:1-mode and switched off, the Ebike
will always start in 1: 1 mode. During this mode the E-Bike behaves as if it was not modified.
3.2. Tuningmode
In order to start the tuning mode, the e-bike has to be switched off immediately after starting in 1: 1 mode (Brose:
press and hold the power button for at least 3 seconds or remove the battery briefly), wait at least 5 seconds and
then switch it on again. So proceed as follows:
1. Switch on E-Bike → [display shows 0,0
, 1:1 Mode]
2. Switch off the e-bike after it has started up completely (BROSE DeepStandby!), wait 5 seconds.
3. Switch on E-Bike → [display shows 10,0
if calibration is correct, tuningmode]
10,0
is displayed on the speedometer to signal that the tuning mode is activated. The actually travelled speed
remains readable during the tuning-mode. Up to 20
, it is issued 1 to 1. Above 20
(mph) the speed will be
displayed over the second number and decimal place. If the speedometer does not have a decimal place, the
displayed speed is accordingly less accurate. Examples:
22.7
→ 27
23.5
→ 35
24.8
→ 48
Automatic route compensation
In order to compensate for the difference between the distance actually driven and the distance displayed, the
maximum speed driven is displayed on the speedometer after about a minute of standing still until the distance has
been covered. As soon as the difference has been compensated, the speedometer drops back to 0.0 km/h and the
e-bike switches itself off after a while. If the e-bike is switched off beforehand, the sIMPLEk saves the difference and
catches up later. As a result, the maximum speed and the distance traveled/total distance are correctly displayed.
Reset maximum driven speed
The maximum driven speed, which is displayed to compensate for the difference in the distance covered, is reset by
restarting the calibration and either carrying it out completely or aborting it by driving off. If the calibration is aborted
by starting up, sIMPLEk jumps into 1:1 mode. The maximum speed is now reset.
To Next Page
Loading...