[Note: If your lock is opening on every turn of the knob or lever, except upon entering a code, this may be a
ZERO CODE. Before attempting to remove the lock from the door, refer to the troubleshooting procedures
outlined at bottom of this document for a zero code symptom/solution.]
Cabinet Locks
9600 Series FAQ
Changing the Code / Combination
Read the instructions through once before attempting to change the combination.
The factory pre-set combination is 2 and 4 pressed simultaneously (and released), then press 3 (and release).
The door must be open.
1. Turn the control knob to the left (counterclockwise) to the stop position and
release (see figure 1). This clears the lock of previously used buttons.
2. Enter the existing combination. Make sure you depress each button fully and
release.
3. Push down the combination change slide on the back side of the lock. Located at
the end opposite control knob (see figure 2).
4. Turn the control knob to the left (counterclockwise) to the stop position and
release (see figure 1). This clears the old combination.
5. Select a new combination, write it down. Some or all of the buttons may be used
for your new combination - pressed individually or simultaneously.
Each button may be used only once. We do not recommend the use of a one-button
combination.
6. Enter your new combination. Depress each button fully and release it. You must
feel a click each time you press a button to know that the button was fully
depressed (see figure 3).
7. Turn the control knob to the right (clockwise) to the stop position and release to
activate the new combination (see figure 4).
8. Enter new combination and test operation.
Note:
Do not force at any time.
To Next Page
Loading...