Simplex 5000 Series - User Manual

Resetting the Code/Combination
Simplex 5000
5000 Series FAQ
Resetting the Code/Combination From a Lost Code
1. Removing Lock From Door
Remove both the outside unit assembly (a) and the inside unit
assembly (b) (see gure 1). Reverse procedures from sections E and F of
this manual.
2. Removing Combination Chamber Assembly
Carefully remove the base plate of outside unit assembly (a) by
removing the 2 Phillips screws (one screw may be found under an
inspection sticker).
Remove the combination chamber assembly (b) from the base plate by
removing the 2 Phillips screws (c) (see gure 2).
Remove the 3-sided dust cover (d) to fully expose the chamber by
removing 2 small Phillips screws (e) (see gure 3). May be 1 screw (x) in
newer models.
3. Resetting and Recovery of Current Code
To reset the code gears (a), each one of the 5 “L” shaped legs (b) of the
unlocking slide (c) must engage snugly with the corresponding code
gear pocket (d) next to it (see gure 4).
Position the chamber in one hand, as shown (see gure 5). Hold
chamber by the top screw tab (e) and bottom screw tab (f).
Rotate the reset cam (g) back toward you with your nger, towards the
key stems (h) as far as it will go and then release. Now look at the code
gears (a) and the unlocking slide (c). Note that some or all 5 of the code
gear pockets (d) are rotated away from the “L” shaped legs (b) as if out of
alignment. Typically each code gear pocket will be at a slightly dierent
distance compared to the other.
Note: There is no way to determine a forgotten, unknown or lost combina-
tion code from the front or outside of the lock. However, it can be reset and
recovered or reset and changed to a new code by following the steps in this
section.
Warning: Since this procedure is of a technical nature, only technically
trained personnel in the lock and hardware eld should undertake this
operation. For further assistance, call the Kaba Access Control technical
support line at 800-849-TECH (8324) or 336-725-1331 between 8AM and
5PM Eastern Standard Time, Monday through Friday (except holidays).

Simplex 5000 Series Specifications

General

Buttons	5
Construction	Heavy-duty
Mounting	Surface Mount
Key Override	Yes
Material	Metal
Backset	2-3/4", 2-3/8"
Door Thickness	2-1/4"
Handing	Reversible
Weather Resistant	Yes
Application	Commercial
Deadbolt	1" throw
Finish	Varies by model (see Finish Options)

Summary

Resetting the Simplex 5000 Lock Combination

Removing Lock From Door

Remove both the outside and inside unit assemblies as per manual sections.

Removing Combination Chamber Assembly

Remove base plate and combination chamber assembly using Phillips screws.

Resetting and Recovery of Current Code

Engage code gears with unlocking slide legs and use reset cam to align.

Clearing Current Code and Setting New Code

Align code gears, press code change button, use reset cam, enter new code.

Reinstalling Chamber Assembly and Retesting

Reinstall dust cover, chamber assembly, and base plate, then test.

Reinstall Lock on Door

Follow manual sections E and F for reinstallation on the door.

Retest New Code With Lock on Door

Enter new numbers and operate lever/knob to confirm lock opens.