KAA1164 0108
5. Reinstalling Chamber Assembly Into Lock and Retesting
Reinstall the 3-sided dust cover over the combination chamber with the 2 small
Phillips screws removed (may be 1 screw in newer models).
Reinstall the combination chamber assembly to the base plate with the 2 Phillips
screws removed.
Reinstall the base plate on to the outside lock assembly with the 2 Phillips screws
removed. Make sure all parts have been reinstalled correctly.
6. Reinstall Lock on Door
By following the procedures in Sections E and F of this manual.
7. Retest New Code With Lock on Door
By entering the new numbers followed by the “ENTER” button and rotating the outside
lever/knob. The lock should open and the latch should retract.
For technical assistance please call
1-800-849-TECH (8324) or 336-725-1331
To Previous Page
Loading...
