12. Try to turn the thumbturn to the right (clockwise) again. The thumbturn will not turn clockwise unless the
correct combination is entered.
Note: Excessive force will slip the thumbturn 180°. The slipping mechanism (force-proof clutch) protects the
lock’s internal mechanism from forced entry.
13. Turn the thumbturn to the left (counterclockwise) to the stop position.
This will clear any previously depressed buttons.
14. Enter the new combination. Turn the thumbturn to the right (clockwise).
The thumbturn should rotate. The latch will be retracted flush with the face plate. The correct combination
must be entered each time you want to unlock the door.
15. Replace the rubber cap to cover the combination change hole.
Troubleshooting
Symptom/problem: Without depressing any buttons, the outside thumbturn always retracts the latch when it is
turned clockwise.
Cause: Lock is in zero combination.
Solution: Follow the procedure for changing a combination except omit step 2 (do not enter the existing
combination).
To Next Page
Loading...