Simplex 4007ES Panels - Mounting Instructions; Semi-flush mounting for retrofit installation; Surface mounting; Verification Procedure

To Next Page

To Previous Page

Mounting

Instructions

1. Using the four provided screws, mount the annunciator in its back box (see Figure 6 for semi-

flush mounting and Figure 7 for surface mounting).

2. Label the separate user-defined labels with the appropriate designation.

3. Carefully pull the top of the label pocket forward and insert the user-defined labels.

4. Gently push on the trim plate to snap it in place, over the annunciator.

Figure 6. Semi-flush mounting for retrofit installation

Figure 7. Surface mounting

Verification

Procedure

When the installation is completed, verify that the remote annunciator is working properly.

If the annunciator displays the message “Error communicating with Master” or if the annunciator

fails to power, check the wiring. If the wiring is correct, call technical support. If the annunciator

is not wired properly and is not communicating with the FACP, error messages are displayed and

an audible signal is emitted. Also, a card missing trouble is displayed at the FACP.

For Programming changes, please refer to the Programmer’s Manual, 579-1167.

#8-32

screws

Trim plate

LCD

annunciator

2975-9463 or

2975-9464 Bracket

Keyswitch

User-defined

labels

6-gang box or

Mansonry box