13
1. Slide the mounting bracket, containing the hard drive, back into the drive assembly. The
topside of the PC board adapter should face toward the floppy drive.
2. Fasten the mounting bracket to the drive assembly by replacing the screws that were removed
on the sides of the assembly.
1. Reposition the drive assembly at the bottom of the case. Make sure the white insulator
washers are in place below and behind the assembly.
2. Replace the screws you have removed at the bottom and rear of the assembly, fastening both
the drive assembly and insulators in place.
1. Connect the other end of the new hard drive cable (734-037) into the hard drive’s PC board
adapter, which you just installed. This connection is keyed and will only fit one way.
2. Connect power to the white, four-pin port on the hard drive’s PC board adapter card. Use the
four-pin connector that extends from the same cable that powers the floppy drive.
Note: You may need to follow the power cable (marked by a white casing on the floppy
drive) from the floppy drive down until you find the unused four-pin connector. It
is a white plastic casing about three quarters of an inch wide. Plug this
connector into the white, four-pin port on the PC board adapter you’ve just
connected to the hard drive.
Fasten the cover back onto the chassis with the four screws you removed from each corner earlier.
Connecting the Hard Drive, Continued
Replace the Hard
Drive and Mounting
Bracket
Remount the Drive
Assembly
Connect Cables to
the Hard Drive
Close Chassis
To Next Page
Loading...
