18
1. Highlight and select “PCI/Plug and Play Setup” from the list on the main setup screen.
2. Make sure that the IRQs 5, 9, 10, 11, and 15 are set to “ISA/EISA” rather than PCI settings.
Note: The setting for IRQ 15 will not be visible on the screen that opens initially. Scroll
down the screen with the down arrow in order to see more of the list, including
IRQ 15.
AMIBIOS SETUP – PCI / PLUG AND PLAY SETUP
© 1996 American Megatrends, Inc. All Rights Reserved
Plug and Play Aware O/S No Available Options:
PCI Latency Timer (PCI Clocks) 64 No
PCI VGA Palette Snoop Disabled Yes
PCI IDE BusMaster Disabled
OffBoard PCI IDE Card Auto
OffBoard PCI IDE Primary IRQ Disabled
OffBoard PCI IDE Secondary IRQ Disabled
DMA Channel 0 PnP
DMA Channel 1 PnP
DMA Channel 3 PnP
DMA Channel 5 PnP
DMA Channel 6 PnP
DMA Channel 7 PnP
IRQ3 PCI/PnP
IRQ4 PCI/PnP
IRQ5 ISA/EISA
IRQ7 PCI/PnP
IRQ9 ISA/EISA ESC: Exit :Sel
IRQ10 ISA/EISA PgUp/PgDn: Modify
IRQ11 ISA/EISA F2/F3: Color
Figure 15. PCI/Plug and Play Setup Screen
3. Press [ESC] to return to the main setup screen.
Highlight and select “Save Settings and Exit” from the list on the main setup screen. Whit
1. Enter “Run Time” to make sure that everything starts up correctly.
2. If OK, exit “Run Time.”
3. Disconnect Batteries.
4. Remove AC power at the breaker.
5. Remove the Keyboard.
6. Reapply AC power at the breaker and reconnect batteries.
7. Start up the system for regular operation.
Configuring CMOS Setup, Continued
Check Settings on
the PCI/Plug and
Play Screen
Save Settings
Verify Operation
To Next Page
Loading...
