Programming
Configuration Process The process of programming the Graphical LCD Annunciator can be broken down
into the following steps.
1.
2.
3.
4.
5.
6.
7.
8.
Configure the job in standard fashion with the 4 100 Programming Unit (at Rev.
8.01 or later).
Build the job to create the cjobname>.eng custom label file and a MOT file.
The MOT is used for burning a CFIG chip for Master FACP.
Copy the <jobname>.eng to <jobname>.lcd.
Translate the labels in <jobname>.lcd into the target language using any
available foreign language editor.
Compile, merge and optimize <jobname>.lcd with [language].msg file using
the PC-based tool (COMLCD.EXE) to generate a new file, cjobname>.bin.
Download cjobname>.bin into the Graphical LCD Annunciator using the
download utility.
Start the system up.
Check the labels for formatting and readability; if any messages are
unacceptable, return to Step 4.
Continued on next page
25
To Next Page
Loading...
